Flat mask inner ear strap machine
The device uses ultrasonic welding to fuse the elastic band to the inner side of the two ends of the mask body. It is the last processing process for the inner ear mask production. Only one operator needs to place the mask body piece in the mask disk, and the subsequent action is completed by the finished product. The device is automatically completed. This machine adopts servo and stepping drive, with precise transmission and adjustable speed.

share it:
product information
The device uses ultrasonic welding to fuse the elastic band to the inner side of the two ends of the mask body. It is the last processing process for the inner ear mask production. Only one operator needs to place the mask body piece in the mask disk, and the subsequent action is completed by the finished product. The device is automatically completed. This machine adopts servo and stepping drive, with precise transmission and adjustable speed.

Machine size
3,200 mm (long) x 950 mm (wide) x 1,850 mm (high) mm
Driving mode
Servo motor and synchronous belt
Electronic control mode
MITSUBISHI Japan
Control panel
Man-machine interface (touch screen)
Voltage
220V, 50/60HZ,1P
Applicable materials
Polyester ear tape
Product specification
Standard type: 175x95mm special type: 145x90mm / 125x90mm
Capacity
About 50 tablets per minute
Remarks
No time